B246A BMW Fault Code

Description:

Catalytic converters must be warm before they can work properly. On a cold start the PCM provides a rich mixture to keep the cold engine running.
All that extra fuel goes into the catalytic converter. But the exhaust isn't very hot, because, ah, the engine is pretty cold. GM has employed several strategies to fire up the catalytic converter quicker and reduce cold start emissions. One way is to use a secondary air pump that pumps outside air directly into the catalytic converter.

B246A Code Symptoms :

The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. B246A code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.

Diagnosis And Repairing B246A

B246A OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.

How to fix B246A code ?

• Air fuel ratio (A/F) Sensor 1 Bank 1 harness is open or shorted
• Continuous oil flow to the VCT piston chamber
• Damaged camshaft position (CMP) sensor
• Variable Camshaft Timing (VCT) position circuit is open or shorted

Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.